IED BUTTON MAKER PROJECT

Introduction: This post will contain useful tutorials for some of the parts of the button maker. Click on the part name to be taken to a Google doc presentation of this part. I hope that these tutorials are helpful.

Page 7: UPPER DIE PRESSURE RING


Page 8: UPPER DIE OUTER RING UPDATED


Page 6: SECTION VIEW FOR THE UPPER DIE CENTER PIN


Page 7: DETAIL VIEW OF UPPER DIE PRESSURE RING

Page 5: PART #10: SOCKET HEAD SCREW (Use this link to take you to a chart that shows all the important Information needed to make the socket head screw)

Dial caliper Quiz

Directions: Use the answer sheet provided to write down the readings for the dial caliper settings below.

Dial caliper setting Number 1: Read the setting and write on the answer sheet. You may copy this image and paste it into a power point slide and then rotate if you like.

Dial caliper setting Number 2: Read the setting and write on the answer sheet. You may copy this image and paste it into a power point slide and then rotate if you like.

Dial caliper setting Number 3: Read the setting and write on the answer sheet. You may copy this image and paste it into a power point slide and then rotate if you like.

Dial caliper setting Number 4: Read the setting and write on the answer sheet. You may copy this image and paste it into a power point slide and then rotate if you like.

Dial caliper setting Number 5: Read the setting and write on the answer sheet. You may copy this image and paste it into a power point slide and then rotate if you like.

Residential Structures: Procedures for constructing the civil war table

Learning how to draw Orthographic Projection

Please click below to go to a presentation that will teach you how to draw Orthographic Projections

 

Click Here

Isometric sketching

This lesson is for the following classes:

• Period 1: Civil Engineering and Architecture
• Period 2: Architectural Drafting
• Period 3: Residential Structures
• Period 7/8: Introduction to Engineering Design
• Period 10: Introduction to Engineering Design

Instructions: 

1. Please pick up a pencil and two sheets of Isometric grid paper from the teachers table
2. Complete the sketches shown below.
3. For each object, use shading to enhance the sketch
4. Make sure that you print your full name and the class period for every sheet of paper that you submit for grading
5. There are 6 objects to sketch and shade with each sketch being worth 16 points
6. If you click on the image it will appear larger in a separate window

http://jmcintyre.wikispaces.com/file/view/1.%20Isometric_Drawings_compressed.jpg/361137964/960x727/1.%20Isometric_Drawings_compressed.jpg

http://evstudio.com/wp-content/uploads/2012/05/isometric.jpg

http://www.automotiveillustrations.com/tutorials/tutorialimages/isometric-drawing-final-line-work.jpg

IED Unit 1 exam

Directions: Click below to be taken to the exam posted on Google drive.
Use a piece of paper to design an answer sheet with 21 answers. Answer each question by choosing the MOST correct answer.

CLICK HERE TO BE TAKEN TO THE TEST

GOOD LUCK!!!

http://www.wired.com/images_blogs/thisdayintech/2010/08/condor.jpg

 

 

Periods 1 and 2 lesson for Wednesday October 8, 2014

This lesson is for Periods 1 and 2 for Wednesday October 8, 2014

Lesson title: Introduction to 2 point perspective drawing

Instructions:

1. Please get some paper, a pencil, and eraser, and a straight edge ( a ruler or a plastic triangle "set square" are all fine).
2. Next o the link below which will take you to a step by step tutorial on how to make this type of sketch

                                                        Click here