Monday, November 23, 2015

Monday November 23 lesson for IED periods 3, 7/8 and 10

Hello!
Please do the following:
  1. Go to the table by the door and pick up these supplies
    1. 1 sheet of Engineering notebook paper
    2. 1 pencil
    3. 1 marker
    4. 1 black plastic fischertechnik engineering block
    5. 1 dial caliper
  2. Make a beautiful sketch of the Marker ( 20 points)
  3. Make another beautiful sketch of the engineering block ( 20 points)
  4. Now take your dial calipers and  practice measuring
  5. Complete 5 different measurements of each item
  6. For the marker, measure the length, outside diameter, length of the cap and two other areas ( you pick) (20 points)
  7. Write your measurements on your sketches showing where you measured
  8. For the engineering block, measure the width, height, and depth. Then measure the depth of the grooves and the diameter of the attachment pin at the top (20 points)
  9. Make sure to place your name, date, and title of the drawing ( Dial caliper practice) in the title block of the engineering note paper (20 points)
  10. Here is a link to a reminder on how to read the calipers: Click Here

No comments:

Blog Archive